SAE AMS 4124F:2019 pdf free

SAE AMS 4124F:2019 pdf free.Aluminum Alloy, Rolled or Cold Finished Bars, Rods, and Wire
The producer of product shall furnish with each shipment a report stating that the product conforms to the composition,ultrasonic inspection when specified, and tolerances and showing the numerical results of tests on each inspection lot to determine conformance to the other acceptance test requirements. This report shall include the purchase order number, inspection lot number, AMS4124F, size and quantity. The report shall also identify the producer, the product form, and the mill produced size.
When material produced to this specification is beyond the sizes allowed in the scope or tables, or exceptions authorized by purchaser are taken to the technical requirements listed in Section 3 (see 5.1.1), the report shall contain a statement “This material is certified as AMS4124F(EXC) because of the following exceptions.” and the specific exceptions shall be listed.
A change bar (l) located in the left margin is for the convenience of the user in locating areas where technical revisions, not editorial changes, have been made to the previous issue of this document. An (R) symbol to the left of the document title indicates a complete revision of the document, including technical revisions. Change bars and (R) are not used in original publications, nor in documents that contain editorial changes only.
Hardness should be not lower than 125 HB/10/500 or 130 HB/10/1000, determined in accordance with ASTM E10.Hardness has been used to verify that product is properly processed, but an out-of-range hardness number is not always indicative of product with out-of-specification tensile strength. Further analysis, including material composition verification, heat treat process parameter review, and/or tensile property measurement, on product with out-of-range hardness may be necessary.
Unless otherwise specified, the material producer shall work to the revision of this specification (AMS4124) in effect on the date of order placement. Unless otherwise specified, material manufactured and certified to the immediately previous revision of this specification (AMS4124) may be procured and used until inventory is depleted.SAE AMS 4124F pdf free download.