SAE AMS 4087J:2020 pdf free

SAE AMS 4087J:2020 pdf free.Aluminum Alloy Tubing, Seamless, Drawn 4.4Cu- 1.5Mg – 0.60Mn 1 (2024-0)
The producer of tubing shall furnish with each shipment a report stating that the tubing conforms to the composition and tolerances (and NDT inspection, when required); and showing the numerical results of tests on each inspection lot to determine conformance to the other acceptance test requirements and periodic test requirements when performed. This report shall include the purchase order number, inspection lot number(s), AMS4087J, size, and quantity. The report shall also identify the producer, the product form, and the size of the mill product.
When material produced to this specification has exceptions authorized by purchaser taken to the technical requirements listed in Section 3, the report shall contain a statement “This material is certified as AMS4087J(EXC) because of the following exceptions:” and the specific exceptions shall be listed.
A change bar (l) located in the left margin is for the convenience of the user in locating areas where technical revisions, not editorial changes, have been made to the previous issue of this document. An (R) symbol to the left of the document title indicates a complete revision of the document, including technical revisions. Change bars and (R) are not used in original publications, nor in documents that contain editorial changes only.
A double flare is similar to a standard single flare except that the flare is folded back on itself such that the cut edge is inside the flare near the ID of the tube. Definitions and ilustrations of single flaring are shown in AS4330; double flaring is defined and ilustrated in AS33583.
Dimensions and properties in inch/pound units and the Fahrenheit temperatures are primary; dimensions and properties in SI units and the Celsius temperatures are shown as the approximate equivalents of the primary units and are presented only for information.
Unless otherwise specified, the tubing producer shall work to the revision of this specification (AMS4087) in effect on the date of order placement. Unless otherwise specified, castings manufactured and certified to the immediately previous revision of this specification (AMS4087) may be procured and used until inventory is depleted.SAE AMS 4087J pdf free download.